40L 10Gal Sandblaster Heavy Duty Steel Abrasive Air Sand Blaster Mobile Rust Remove Surface Cleaning Recondition Machine

Operating procedure:
1. Add sand to the feeding port, and then tighten it.
2. Close valve 1 and valve 3, open valve 2, and connect the air pump to pressurize the tank. Note that the air pressure should not exceed 8kg.
3. After the inflation is completed, close valve 2, open valve 1 and valve 3, and then turn on the switch of the sandblasting gun to start working.

Product Features:
1. The pressurized design has 30% more blasting intensity than the siphon type sandblasting machine.
2. Suitable for partial surface treatment of immovable and large workpieces
3. Adopt press-in type sandblasting, which is suitable for surface treatment requirements with high sandblasting density
4. Equipped with a gas-water separator to meet higher sandblasting requirements
5. Caster wheel design, moving more convenient and flexible
6. Remove rust, oil and impurities more thoroughly

Points to note:
1. Do a good job of personal protection before work
2. Do not use higher working pressure than permitted
3. Use clean abrasives to prevent the spray gun from clogging
4. After the work is over, the air pressure in the tank should be released to zero

Instructions for use:
With a 3.5mm nozzle, the sand consumption is about 180 kg/hour.
The amount of sand loaded at one time is about 2/3 of the barrel.
If the loading capacity of a bucket of sand is 25 kg, it will take about 10 minutes to finish the spraying.
If it is used all the time, it needs to be filled about 10 times a morning.

Supporting use of air compressors (customers who do not have it, need to purchase additionally):
Minimum required power: ≥3KW (recommended configuration power ≥4KW)
Pressure: 0.6-0.8mpa
Air compressor discharge volume: air compressor with displacement ≥ 0.6M3 /min