Stainless steel cold glue applicators paper label edge wallpaper hotmelt folding glue machine

Product Specifications

1. Gluing width: 700mm

2. Thickness of the adhesive layer: 0.03~ 0.1mm

3. Motor power: 220V 50Hz

4.Power: 120W

5. Motor speed range: 0 ~30M / Min

6. Machine weight: 60KG

7. Dimension: 1000mm*430mm*320mm

The glue machine is a kind of special equipment for printing fine box and carton. It is a special equipment for glue, paper and corrugated paper. It also makes one kind of plastic sheet.

Stainless steel desktop speed control glue machine is the printing and packaging industry, the paper on the special equipment, the machine uses a large number of stainless steel components, aluminum alloy components, greatly improving the corrosion resistance of the device, the machine uses advanced speed motor, To meet the needs of a variety of paper on the plastic, the appearance of the machine beautiful, simple structure, smooth transmission, easy maintenance.

Instructions for use

1, Installation:

The machine must be placed on the level of the face, not a serious tilt phenomenon, otherwise, will make the glue to the end of a gathering out of the glue tray

2, test machine:

(200V/50Hz) Turn on the power switch (this switch and the motor knob on the same electrical board),  the machine starts to rotate from slow to fast.

3, adjustment:

A. The thickness of the adhesive layer adjustment: at the same time rotating rubber layer thickness adjustment handle (the handle left and right each one), so that with the roller before and after the move, and the gap between the roller changes, Thickness of the adhesive layer. Then, tighten the screw on the screw can be. Adhesive thickness adjustment range of 0.03 ~ 0.10MM.

B. Adjustment of the platen roller: Loosen the star handle on the handle (the left and right) of the platen roller to rotate the nut under it, and move the platen roller up and down. So as to bring up the gap between the paper, note: this gap should be at least greater than the above mentioned layer thickness. Otherwise it will make the paper roll with glue.

Plastic removable disk:

The plastic tray structure is parallel to the quadrilateral mechanism, simply press the counterclockwise direction gently pull the plastic tray handle to the downstream limit can be removed from the plastic plate, let go, the frame will automatically reset, repeat the above procedures, The tray is loaded.

Maintenance and repair

1, When using the motor speed control knob, only slowly rotate until you are satisfied with the speed.

2, rubber tray tray must be pressed to press the glue tray loading and unloading handle, let it slowly reset.

3, the relative movement points must always add lubricating oil.

4, After each class, you must clean the machine residual glue to prevent corrosion parts.