industrial automatic LED display pressure control switch for water pump 1.1KW

Automatic water pump controller

Technical Parameters

Rated voltage "220V-240V, 110V-120V, 110V-240V

Frequency: 50/60Hz

Maximum current: 10A

Maximum power: 1.1 KW, 1.5KW

Starting pressure: 1.2Bar, 1.5Bar, 2.2Bar

Maximum working pressure: 10Bar

Interface thread: R1"

Protection level: IP65

Maximum operating temperature: 60 degrees Celsius

This electronic controller will start automatically or cut off the power when turned on or off any tap or value in the system.If a tap in the system is turned on,this controller can generate constant pressure and keep the flow normal during the water pump operation.

Application:

Device for automatic control of electric water pumps,water shortage protection,Automatic restart after water shortage, the restart Interval time is 8S,1minute,3minutes,10 minutes,30minutes1 hour,half an hour,2hours ,than per 2hours cycle…
The product can replace the complicated installations of automatic water pump e.g. pressure gauge, pressure switch, T-valve, check valve and pressure tank ). It has the features of stable performance, low maintenance and long life etc,. It will indicate the pump has started when the green light Power on lights up after connecting the power. When the yellow light Pump on lights up, it indicates the pump has been started. The pump continues to operate for a few minutes enabling the system to fill in the pipes and to reach the required pressure. If this lapse is insufficient, the red light Failure will light up. In this event, keep the Restart button pressed and wait, with a tap opened till the red light is off. Once released the button and closed the tap, the product will keep the pump at its maximum pressure.