Tesla Coil HFSSTC 10 Minutes Electronic Candle Plasma Flame High Frequency Voltage Generator DC 36V-48V Technology Toys DIY

Tesla Coil HFSSTC 10 Minutes Electronic Candle Plasma Flame High Frequency Voltage Generator DC 36V-48V Technology Toys DIY

Notice:
Product without power plug！！！

Description:
Plasma, also known as plasma, is an ionized gas-like substance composed of positive and negative ions generated after some of the electrons are deprived of atoms and ionization of atomic groups. It exists widely in the universe, and is often regarded as the fourth state of matter existence except for solid, liquid and gas. Matter is composed of molecules. Molecules are composed of atoms. The atoms are composed of positively charged nuclei and negatively charged electrons surrounding it.

Specification:
Name: Hfsstc (high frequency Tesla coil) commonly known as "electronic candle"
Working voltage: DC 36V-48V
Working current: 1.8-2.5A
Working frequency: around 15mhz

Safety precautions:
--Please use strictly in accordance with the instructions, if improper use is likely to cause fire, electric shock, burns and other accidents.
--Parts that are strictly forbidden to touch during work: the secondary coil, the top coil of the main unit, and the output discharge needle of the main unit.
--Do not use over-voltage, the working power supply voltage should not be higher than DC 52V.
--Don't change the parameters arbitrarily.
--The positive and negative poles of the power supply are strictly prohibited.
--The recommended working time is less than 10 minutes. Exceeding the time will cause high temperature aging and damage to the ignition coil.
--To ensure safety, please make sure that there are no flammable and explosive materials around the product before work.
--When working, it will produce certain electromagnetic interference to the surrounding electronic equipment.
--This product is not waterproof, please do not use it in an excessively humid place.
--Do not use objects to connect the high temperature tape part of the primary secondary coil during work to avoid secondary damage.

Use steps/methods:
1. Place the host and connect the host and secondary coil correctly.
2. Connect the power supply and the fan starts to work.
3. Turn on the switch, and the indicator light next to the switch is on (the left side of the switch is on and the right is off) the indicator light on the bottom of the coil is on.
4. Touch the top of the secondary coil with metal as soon as possible to ignite the flame.

Note:
If the power indicator is on but not working after turning on the switch, you need to adjust the potentiometer on the host.

Adjustment method: After turning on the switch, slowly rotate clockwise until the signal light on the top of the main engine lights up, and the secondary ignition coil can be ignited. Adjusting to just the arc is the best state, too large will cause the main circuit current to be too large or even damage! (All have been debugged before shipment, use this method to adjust under special circumstances)