Regenerative desiccant air dryer supplier

Heatless regeneration desiccant compressed air dryer

  Applicable working conditions
Max air inlet temperature：45℃
Working pressure range：0.5-1.0Mpa
Pressure dew point：-20℃~-40℃
Pressure loss：≤ 3% of design working pressure
Oil content of air inlet ：≤0.1PPm
Control mode：Micro computer/PLC controller
Power:AC220V/50HZ,
Working cycle: T=10(min)

 Product features
10 minutes standard cycle;
Working pressure dew point -20℃~-40℃；
High-quality switching valve, stable and reliable, can ensure the integrity of the work process and prolong the working life of components;
Choosing Special adsorbents with highly hygroscopic , uniform shape and size, high strength, low output dew point, less dust generated, and long service life;
The amount of regeneration air can be adjusted according to the operating load requirements of the equipment to achieve energy saving effect
Reasonable heater design, good dehumidification and regeneration effect, low air consumption, high heating efficiency, and minimized energy consumption;
Programmable microcomputer controller, that adsorption and regeneration time can be adjusted to achieve your satisfactory dew point value;

Table 1：Working pressure correction factor CFP

   Table 2: Air inlet temperature correction factor  CFT

   Selection process

  The pressure loss of the pre-filter in the system must be considered
when choosing the correction factor CFP of inlet pressure of dryer.
Select the air inlet temperature correction factor CFT.
Selection calculation formula: selection treatment capacity = actual treatment capacity÷(CFPXCFT)    

 Product specifications