Best quality of manual electric wheelchair ramp conversion kit from Chinese factory

NC-B1 Introduction:

A.When push the wheelchair, the controller will automatically detect the running state of the wheelchair and start the motor, pushing the wheelchair forward, to achieve the assistance effect.

B.When the need for wheelchair automatically forward, only the continuous application of the wheelchair thrust, wheelchair can be based on the actual situation before the uniform.

C.When the wheelchair backward sliding, the controller will automatically lock the motor, the faster backward sliding speed, the greater lock force for motor, to prevent the wheelchair backward sliding.

D.The NCB1 is lightweight and easy to install. It can be fit on essentially any make and type of wheelchair, including folding, tilt-in space, one-arm drive and standing.

Certification of Electric bike kit":

UPDATED CERTIFICATION OF MOTOR AND BATTERY:

http://www.iset-italia.eu/RICERCA/class/

Company Name: Changzhou Ncyclebike Co., Ltd

Certificate No: IT091550NC160622

Certificate No: IT081550NC160622

Using steps:

1. The Maximum carrying capacity is 100kg.

2. Set into the wheelchair and turn on the switch and turn the auxiliary wheels by hands. When the hub turns a half circle, NC-B1 starts working.

I. speed:2.5-4.0Km/h

II. speed:2.5-7.0Km/h

PS: When you go down a hill and your speed is faster than the max speed, NC-B1 will enter hibernation. When your speed is between the speed range, the system will be resumed from hibernation and will work again.

3. Ideally, when NC-B1 works, you don't need to turn the auxiliary wheels any more, and the wheelchair will run in a straight-line. But in practice you should adjust the direction all the time according to traffic conditions and pavement conditions.

4. NC-B1 don't have the climbing ability. In order to climb hills, you should turn the auxiliary wheels by hand.

5. When the wheelchair stops for more than 2 seconds, NC-B1 will enter hibernation. When the hub turns a half circle, the system will be resumed from hibernation and will work again. Only turning off the switch can stop NC-B1 from working indeed.

6. When the wheelchair runs backward, NC-B1 will bring an astern resistance.

7. When the light is green, NC-B1 can function properly. When the light is red, you should charge up NC-B1.

8. The battery has been charged up before leaving the factory. When you charge the battery, please at first insert the output of the charger to the charging hole, and then plug the input in with alternating current. Red light means it's on charge; green light means the charging is complete.

Installation drawing:

Using attentions:

1. When you want to use NC-B1, please set into the wheelchair before turning on the switch.

When you want to stop NC-B1, please stop the wheelchair and turn off the switch before leaving the wheelchair.

2.No leaning back hard, in case of roll-over.

3.If you do not use NC-B1 for a long time, please charge it every three months.

DELIVERY TIME:

3 days after confirming order,detail delivery date should be decided order quantity.