Multimeter Digital Voltmeter Ammeter Current Power Energy Watt Volt Amps Meter Blue LCD Backlight DC 100V 20A Current Shunt

A. Function

1. electrical parameter measurement function (voltage, current, power, energy).

2. The voltage alarm function (over voltage alarm thresholds, backlighting and voltage flicker tips).

3. The power button function.

4. Power-down data storage function.

5. Large-screen LCD screen full display function (display voltage, current, power, energy).

6. backlight.



B. display and key

I.Display Interface

Display voltage, current, power, energy parameters from the large-screen LCD screen simultaneously.

II. Display Format

1kW display format within 0.0 ~ 999.9W;

From 1kW display format 1000 ~ 2000W.

2. Power: measurement range 0 ~ 9999kWh

10kWh within the display format 0 ~ 9999Wh;

Above 10kWh display format 10 ~ 9999kWh;

3. Voltage: test range 6.5 ~ 100V

Display Format 6.50 ~ 99.99V

4. Current: Test Range 0 ~ 20A

Display Format 0.00 to 20.00.

III. Button

1. The backlight control

By short press the button to turn on or off the backlight, the backlight status automatic storage.



2. The power ed

Step 1: Press the button until the power area show "CLr" character, then release the button;

Step 2: At this point in the power consumption flashing indicating the current status is ed, if short press the button again, the

consumption data is ed and ed quit flashing;

Step 3: If no key is pressed within five seconds, it means that the power does not the data and exit ed.

3. The voltage alarm value

Step 1: Press the button until the power area show "SET" character, then release the button;

Step 2: After entering this state, the voltage of the high pressure area shows the current alarm value, the current area displays

the current value of low pressure alarm, and the least significant bit starts flashing, then you can press the button through the +1 bit short,

when there is no button operation When more than three seconds, the automatic adjustment of the position switch from high pressure to

low pressure alarm alarm value has a value, a total of six, the scope voltage alarm threshold set for the 6.5 ~ 99.9V;

Step 3: After setting, press the button until the display shows "PASS" character indicates the setting is successful and automatically exit the setting mode.

4. Power: measurement range 0 ~ 2kW

C. Notes

1. This module is suitable for indoor, not outdoor

2. applied load can not exceed the rated voltage and current.

3. The wiring order can not be wrong.

D. Specifications

1. Working voltage: 6.5 ~ 100VDC

2. Test voltage: 6.5 ~ 100VDC

3. Rated power: 20A / 2000W

4. Measurement accuracy: 1.0