Glue High Density Polyurethane Foam Spray Tube PU Adhesive Foam Spray

Glue High Density Polyurethane Foam Spray Tube PU Adhesive Foam Spray

is one-component polyurethane foam which expands and cures through absorption of moisture from tha air. The product is recommended for mouncting windows and construction projects.The PU foam is available in gun/pipe applied version and with manual adaptor.

Application:

Instaliing,fixing and insulating of door and window frames.Filling and sealing of gaps, joints, openings and cavities.Connecting of insulation and roof construction.Insulating the electrical outlets and water pipes.Heat preservation,cold and sound insulation.Packing purpose,wrap the precious&fragile commodity,shake-proof and anti-purpose

Benefits:
--High thermal insulation properties
--Water and moisture resistant
--Suitable to many application in decoration and window and door

Application instruction
Instaliing,fixing and insulating of door and window frames.Filling and sealing of gaps,joints,openings and cavities.Connecting of insulation and roof construction.Insulating the electrical outlets and water pipes.Heat preservation,cold and sound insulation.Packing purpose,wrap the precious&fragile commodity,shake-proof and anti-purpose.

Surface preparation
Surface should be cleaned of dust and mortar colds
Surface should be sprayed with water using water sprayer
Protect window profiles from the foam's outgrow

Product preparation

The can temperature should be between +10℃ to +30℃
Optimal temperature of can is +20℃
If can temperature is too low,the product should be put into warm water of +30℃ for 15 minutes or left overnight in room temperature.

Product Application Instruction
Shake the can vigorously(20-30 seconds valve down)in order to mix the components
Screw the can onto the adaptor
The wroking position is valve down
Vertical gaps should befilled from down to up
Do not fill the whole gap-foam grows in volume
If you fill window or door gaps,the gaps maximum gap size should be 3 cm.Foam should not be used in gaps larger than 5 cm
The speed of application and the thickness of the bead should be controlled by the adequate pressure on the gun or adaptortrigger.
If you stop the application for time longer than 5 mins,remember to shake the can before continuation of works.

Fishing works

The excess of foam should be cut after the foam has cured.The foam should not be pushed back into the gap when it's still uncured as it will cause structural defects and worsen insulation effect.
After the foam has fully cured it should be proteted from UV by mortar or paint.
If you want to keep using the same can after longer time the gun and the adaptor and valve should be cleaned with the cleaner for polyurethane foams
Mechanical connectors recommended for doors mounting

Storage and transportation

Products must be transported and storedin temperatures +10-30℃
Products must be kept upright at all times

Products

Certificate: