Nano Mist Blu-ray Hair Spa Equipment For Hair Salon

Instructions

1. When using this machine, use purified water to make distilled water. It is forbidden to add flavor liquid or use tap water. If it causes the inside of the machine to be blocked, which will seriously affect the service life of the machine and lead to machine damage, it will not be covered by the warranty.

2. When the power is turned on and the power switch is turned on, the fog nozzle of the nano nozzle must be facing the ground. It should not be directed at people, machinery, etc. to avoid unnecessary damage. The water temperature is different, and the waiting time for spraying mist is different. Normal temperature usually waits for 1-2 minutes.

3, the indicator light, it began to spray. Note that the spray opening should not be too close to the person's skin. In order to avoid high temperature damage to people.

Cleaning Process

Please be sure to clean the internal pipe of the machine for about 30 hours every time to prevent pipe clogging.

cleaning method:

The water in the water bottle is drained, and white vinegar (not white vinegar) is used. Then, as in the normal work flow, the machine is started and white vinegar is sprayed into the machine to indicate that the pipe is being cleaned. Clean for at least 20 minutes. After the cleaning is completed, the white vinegar left in the machine water bottle needs to be cleaned, and a bottle of pure water is injected. The machine is started again, the white vinegar remaining in the machine is cleaned, and the fresh purified water is sprayed.

Precautions

1. Water bottles need to use soft water (such as: purified water, distilled water), can not use hard water (such as: tap water, well water, spring water, etc., water can not add any additives) after each operation, the water bottle should be filled with water . If there is no water in the water bottle, the machine will make a (tick) sound, this sound appears as a lack of water inside the motor, the sound of the warning issued, please immediately shut down, fill the water bottle and use it.

2. When the machine is started, the fog outlet must face the ground. After the preheating, the gas will be sprayed, and the water-free bead can be used (about three minutes). It is normal for a small amount of liquid droplets to be sprayed when the machine starts up. (The liquid droplets are formed by the cooling of steam left in the pipes after use.)

3, please do not modify the machine during work.