|
Name
|
Craft beer dispenser for glass growler
|
|
Spear
|
ABS Plastic with 15psi pressure release value
|
|
Regulator
|
ABS plastic Manual Press CO2 Charger
|
|
Tap
|
black ABS plastic tap
|
|
Accessories
|
Brass adaptor, beer tube, 2 worm clamps
|
|
Feature:
|
Eco-Friendly, Water Soluble, Other
|
1. A floppy rubber tube with a black plastic cock in it (another name for tap you pervert)...
2. Attaches directly to the plastic keg and growler spear above.
3. Attaches via a ball lock disconnect to the "Double Ender" spear (get one here).
4. Consists of a length of beer line with a plastic tap clamped to the end.
5. The lightest and smallest tap option.
6. Perfect for sharing a keg between friends in the middle of a table.
7. The only tap that can be easily used while the kegs are laying on their side in the fridge (with either the plastic or the double ball lock spears).
8. Super cheap and easy to replace compared to the chrome or steel tap options.
We always recommend getting one of these as a backup, for out and about etc.
If there you do not have any special requirements , we will send the goods no more than three days. If there has any delay, pls. feel free to contact with us directly.
Packing
Neutral packing, easy for secondary sales and secondary packaging. It is good and convenient for dealer.
|
Trouble shooting
|
Solution
|
|
Leaks gas as soon as the cartridge is installed
|
1.Make sure the regulator dial is off turned all the way counter close
2.Tighten the cartridge seal
Replace the CO2 cartridge it is damaged |
|
|
Make sure the CO2 cartridge is installed, the cap is turned on, and pressure is indicated on the pressure gauge.
|
|
without stopping when closed
|
1.A few drips after closing the tap is normal. But it should not drip over time.
2. If the keg and tapping system is clean, internal O-ring may have worn through use and be in need of replacement. |
|
|
1.First pour may be foamy if the beer line is full of air after being filled or the tap assembly has been allowed to warm up. Second beer should pour fine, if that's the case. Keep out of the sun.
2.Beer may be highly carbonated from the bar or brewery. If beer in keg is pressurized at 5 psi but came from brewery beer line pressurized at 25 psi, beer will pour foamy until the pressure equalizes after few days in the keg. Be sure to open the tap handle fully and let go during the pour. Attempting to meter the flow during the pour can lead to foaming. |
