- Product Details
- {{item.text}}
Quick Details
-
Applicable Models:
-
For all vehicles
-
Place of Origin:
-
China
-
Brand Name:
-
Diagauto
-
Model Number:
-
OBDEMOTO-302
-
Warranty:
-
12 Months
Quick Details
-
Car Fitment:
-
Honda Motorcycles
-
Voltage:
-
Standard
-
Power:
-
Standard
-
Applicable Models:
-
For all vehicles
-
Place of Origin:
-
China
-
Brand Name:
-
Diagauto
-
Model Number:
-
OBDEMOTO-302
-
Warranty:
-
12 Months
Operation Manual
It shall be forbidden to use when don't understand this manual .
Please press the manual shown in procedures.
I:Introduction for different parts
II :How to use
III:Safety
I:Introduction for different parts
II: Operation
1. Screw the bottle and fill the cleaning fluid into bottle, put the bottle as-is impaction (Note: when connect the bottle, don't forget take a strew and the seal).
2. Remove the petrol pump insurance, let the petrol pump can't work.(must be do this step before cleaning)
3. Engine into the tubing will be removed, corresponds to the inlet connector is connected, connect the liquid line (red line);
4. The engine back to the tubing will be removed, the engine of the return pipe mouth with suitable connector plug;(if there is no return pipe of engine, needn ’ t do this step);
5. Connect the air supply, regulating, start the engine, make the engine work normally and cleaning;(pressure regulating is about 2.5 kg/ cm² , but must be according to the car's engine required pressure to set).
6. Cleaning time is about 25 minutes or use out of the new cleaning fluid
7. End of the cleaning, dismantling takeover, restore engine inlet pipe, according to the sample start the engine, refueling, appropriate check each tubing place without leakage.
8. Clean up the scene, for later use.
III: security information
Wear a colorless glasses, as much as possible to avoid the gas, such as cleaning fluid spray to the eyes.
1. It is forbidden to close to the "cleaner" dangerous behavior , such as smoking and ignition, in order to avoid fire and explosion.
2. It is strictly prohibited to spark combustion or near items such as cleaning the scene.
3. It is strictly prohibited to take over, fuel oil and cleaning fluid flow to the engine.
4. Work place in the ventilated place as far as possible, lest nitrides breathe.
5. Work place must be prepared to fire extinguishers and other fire equipment.
6. Emissions of air compressor water, in order to avoid excessive moisture into the washing machine and cause failure
7. Do not inhale by cleaning machine and engine give off cleaning fluid.
8. Before operation, open the cap of tank.
9. After completion of cleaning air connector must be cut off, and then the other connection tubes
10. When cleaning, if cleaning equipment and various a joint leakage phenomenon, should be deal with immediately, and then conduct cleaning work.
11. When using the device, can't let the pressure more than the rating of the device.
12. Use the original factory designated by the agent, in order to maintain the machine within the oil valve, rubber and other parts of life and the effect of cleaning.
13.Please read and do understand this machine operation process, then use, and maintenance to maintain the machine in the best condition, reduce the occurrence of a fault.
