Hydraulic hose fitting crimping machine swage machine wire crimping tool air suspension air shock crimping machine

Specification

C rimping force: 800T/8000kN

Max opening: 170mm

Cri mping range: 70mm-170mm

Acurracy: 0.01mm

Standard dies sets : 4 (size customized)

Voltage: 220V/380V

Power: 3kw/4kw

System pressure: 31.5Mpa

Operate mode: auto, manual, pedal

Weight: 650kg

Dimension: L1200*W600*H750mm

crimping way : Radial withhold

This  is our new hydraulic hose crimping machine, can crimp all types of

hydraulic hoses.

1.Air spring crimping machine provided with die sets range for 1/4' to 1 1/4' ID hoses.

2.Double angular surface-swaging force up to 450T, powerful yet makes crimping easy.

3.Piston,Cylinder,All dies are wire cut after hardening and grinding.

4.Powder coating body give it a Futuristic sleek & stylish looks.

The brief introduction of high pressure hose crimping machine:

Crimping machine connect rubber, plastic and steel rings through hydraulic power. It applies locking pressure through the mold of crimping machine to swage the metal joint on the matched auto air springs and high-pressure oil pipes, so as to complete the installation assembly.

It’s applicable to air spring, all kinds of machinery high and low pressure oil tube, air tube, automobile power steering tube, oil pipe, gasoline supply pipe, as well as buckling of construction fittings and hot water pipe.

It’s also widely used in vehicle, engineering machinery, hydraulic machinery, agricultural machinery and so on.

Rules

1. The operator should operate strictly according to operating rules.

2. The power supply must be switched off when work is done.

3. Exchange the moulds after the shutdown.

4. The locking head and mould base shall keep internal cleanliness, no metal filings and the foreign matters.

5. Inject the lubricating oil into the mould base inclined plane before startup.

6. The mould should keep balance when installing the modules.

7. The pressure regulating valve must be regulated under authorised pressure.

8. When working, the hand should not stretch into the locking head.

9. When inspecting the machine, operators must comply with electrical safety regulations.

Notices

When buckling, make the joint to locate the mould center as much as possible, the joint is not buckled on the hex nut.

Prevent tool and other foreign matter from entering the locking head.

After the work is finished for each time, the eight-block mould base must be made to extend to the greatest extent, this can make the spring to be at extension status. If not, the spring will be damage.

When working, the hand should not stretch into the locking head.

The power supply must be switched off when maintenance is done.